02-12-2021 10:11 AM - edited 02-12-2021 10:13 AM
Hi,
Scenario: A cluster architecture as shown below where two HAS servers along with IIS servers are behind a load balancer.
How can the above 2 HAS servers use same configuration as it was done until V4 with the help of “Share Configuration” file?
It seems that it is possible to attach several HAS servers with the help of “Cluster Join Token”, if yes, where to add this token – didn’t see an option during the installation?
This is where the token is generated from:
Can someone please guide?
Solved! Go to Solution.
06-10-2022 04:38 PM
11-08-2022 07:58 PM
I'm sending you the doc by email; when Olivier gets back we'll check they are available to the rest of the community
20-05-2022 11:09 AM
Hello,
Is there any documentation or instructions available on setting up communication between the two servers mentioned/highlighted below?
28-03-2022 05:17 PM
Hello,
I don't really get you question by what adress .
Here is a more details schema to help clarify
25-03-2022 11:57 AM - edited 25-03-2022 11:58 AM
@oguimard
A follow up question: what address will be used on the two servers when intances are created? Shoud it be the loadbalancer address on both servers or their own address with respective server names?
05-01-2022 10:11 AM
Thank you !
03-01-2022 10:23 AM
Hello,
In V5 CP1 the mechanism to create a cluster is different than in V4.2. The documentation has not yet been updated.
In your situation :
Screenshot Add cluster node :