How to get coordinates of an object into a Diagram

[agiovannetti]

How could I get coordinates of an object into a Diagram. I could see DrawingItem method "setPos....", does exist the getter method too?

[lionel · Accepted solution]

Ciao Andrea,

you have to use the "left", "top", "right" and "bottom" properties of your drawing object.

For example :

Set myDiag = getObjectfromId("xxxxxx") 'Where "xxxxxx" is the _idabs of your diagram
Set oDrawing = myDiag.drawing("RW")
For each oDrawingObject in oDrawing.DrawingObjects
  If oDrawingObject.getId = "yyyyyy" 'Where "yyyyyy" is the getId of the concerned object
  msgbox "Left : " & oDrawingObject.left & vbcrlf &_
         "Top : " & oDrawingObject.top & vbcrlf & _
         "Right : " & oDrawingObject.right & vbcrlf &_
         "Bottom : " & oDrawingObject.bottom
Next

Regards,

Lionel